Allow the washer to sit for approximately half an hour before restarting the cycle. If the dishwasher still does not drain, contact a service technician to inspect the dishwasher and determine the problem. Opening the lid will allow the customer to view and redistribute the load. If the control board fails, all the parts cannot function without it. As you start to unscrew it out lots more water comes out. If the lid switch is functioning properly, go to the next step. The pressure switch, as well as the electronic module, can be checked with a multimeter.
If the code reappears, the motor may have an issue that requires a service call. With intuitive, responsive controls, sleek, stylish designs, and eco-friendly features, our collection gives you the power to do more at home and on the go. If there is an error reading this data, it will cuse this error. To find who made your appliance, check the first three digits of your model number against the list below and this will give you the manufacturer of your appliance. This time of year it can also be a partially frozen water pipe. If the controller fails, the error will disappear.
It will try to unlock the door 6 times before displaying the error. Once identified, pull the plastic hose off the water level switch and blow air into it. If cleaning the pump filters doesn't work there are youtube videos explaining how to replace the pump. The washer does not receive water. It is necessary to change the water supply valve. I hope this will help and let me know what you find and use the thread link to ask any further questions.
I put the detergent in and started the machine. It is located in the place where the inlet hose is connected to the washing machine. That leads to the error code appearance. The water supply valves are not turned on fully or the inlet hoses are kinked, clogged or frozen. Make sure there is water supply reaching machine. People who have city water will probably not have this problem with this machine. Check screen at inlet water valves where hoses connect to machine for blockage.
Therefore, always open the shut-off valve fully. The water inlet valve requires sufficient water pressure to function properly. Try unplugging the Unit for two minutes to see if that fixes the error. Cause: the thermistor is out of order. Testing on a workbench may show the impeller spinning, until the impeller undergoes a load, where it will stall.
Some users read this fault as 1E because I and 1 symbols are almost similar. Thanks for your helpful tips I too have well water and I will have to pull out my machine and do a thorough investigation. You can enter your model at for diagrams and illustrations. It will try to lock it 6 times before displaying the error. In order to get the best possible experience from our website, please follow below instructions. Or If the control has turned the water valves on and after 8 minutes the flow meter has detected 10. Cause: the sensor switch assembly is out of order.
We think the next thing to change would be the valve. Rebalance laundry load and close lid. We ran a test cycle, still does the same thing. Something is preventing the water from coming in. Unplug the unit to service. This may signify problems with the drive motor, thermal protector, or motor controller.
That link for a previous answer that Marc posted in the above response may help you with this problem. We assume no responsibility for any action you may undertake as a result of using this guide. Well, first off, disregard the idiot directions on the box. If the water pressure is adequate, try cleaning the screens inside the water inlet valve hose connection ports. A visual inspection of a wire harness doesn't give a full assessment of its integrity-- you have to measure continuity of each wire in that harness to know what's really going on. Over-loading the unit may cause this problem.